Turning

Turning DEPARTMENT

We work with high-quality technological machines, which guarantee the best performance.


processing type

BAR TURNING, where we work diameters ranging from 6 to 80 mm.
The bar turning allows the direct processing of the whole bar, from which we can obtain pieces of various shapes and sizes, with the aid of motorised milling. Using machines with the tailstock, we can achieve shafts of 250/300 mm in length.

SECONDARY TURNING, where we work diameters ranging from 81 to 200 mm.
Once you have obtained a semi-worked piece by cutting, it is subjected to turning. This type of processing is done with a single spindle machine when the piece is small and not very complex, and with two spindles when instead the piece requires a complete processing and its quantities are greater. In the case of pieces that have long lengths, we use machines with the tailstock.

BAR TURNING AND SECONDARY TURNING, where we process pieces from the bar and, at the same time, from secondary turning from 20 to 80 mm of diameter.
This kind of turning allows the bar and secondary turning to be done in a single phase . Thanks to the use of the counter spindle is possible to avoid steps and the manual positioning of other machines, making the process reliable and precision.


used equipment

DOOSAN PUMA 2600Y


Work performed

equipment×

DOOSAN PUMA TT1800


Work performed

equipment×

MORI SEIKI NL 2500


Work performed

equipment×

OKUMA LB-300-M L500


Work performed

equipment×

OKUMA LB-300-MW


Work performed

equipment×